With more than 50 years of experience in bulk handling, Tratec Solutions has developed belt conveyors of very high quality in terms of both performance and service life. The channel conveyor is manufactured as an NSL type for lighter tasks in crushing plants and industry or as an NST type for heavier tasks in heavy industry.

1. NSL CONVEYORS

NSL channel type conveyor

• The geared motors have a capacity of up to 7.5 kW.
• The drums have a diameter of 270mm.
• The drive drum is equipped with a flange bearing.
• The turning drum is equipped with internal bearings and the shaft is attached to a manual tightening mechanism.
• The rollers have a diameter of 108mm, have bearings with sealed gaskets and are lubricated for life.
• Cushioning elements (shock elements) can be supplied in load zones.
• Rubber belt quality is determined by the material to be transported.
• The loading box is mounted in the loading zone. It is equipped with rubber seals against the belt to prevent spillage.
• Optional extras: Support, walkways, emergency stop system, speed guard, and skew guard.
• Surface treatment: Main parts sandblasted, primed and painted according to Tratec Solution standard. Bolts, brackets and smaller parts are galvanised.

2. NST CARRIERS:

NST duct conveyor

• The drums have diameters up to 400 mm.
• The drive drum is rubberised and equipped with well-dimensioned foot bearings for heavy loads.
• The return drum is equipped with well-dimensioned bearings and the shaft is attached to a manual tightening mechanism.
• The carrier rollers have diameters up to 133 mm, are self-lubricating and have bearings with sealed gaskets.
• Cushioning elements and shock elements can be supplied in loading zones.
• Rubber belt quality is determined by the mass to be transported.
• The primary and secondary scrapers are mounted on the drive drum, while the plough scraper is mounted on the return belt in front of the turning drum.

• The loading box is mounted in the loading zone. It is equipped with a rubber seal against the belt to avoid spillage and Hardox wear plates for better wear resistance.
• Optional extras: Support, roof, sidewalls, walkways, emergency stop system, speed guard, and skew guard. The conveyor can be delivered enclosed to prevent dust emissions to the surroundings and it will then be weather protected.
• Surface treatment: Main parts sandblasted, primed and painted according to Tratec Solution standard. Bolts, brackets and smaller parts are galvanised.